Basketball Court Stencil/Marking Kit
Before You Start
Tape the string/nail (plumb bob) to the center/front of the backboard so that the nail hangs just slightly above the court surface. The nail indicates the STARTING POINT
Unfold one turn of each of the six stencil sections and place them down as shown in the picture above so that the starting holes line up like dominos. The corners of the two panels with single starting holes meet at the starting point.
Unroll one center section (next to the STARTING POINT) straight out onto the court, taping it down flat as you unroll. Unroll another section next to the fist one, but before you tape it down check to make sure the free throw line line is straight. Check your court size as well. If it has less than 21 feet from the starting point to the end of the court, you may need to move the starting point behind the backboard to allow the top of the key to be on the court. Now unroll and tape the rest of the sections keeping the stencil flat, the edges together, and free throw line straight. finished court size is approximately 13 X 21 feet.
Roll the paint over the stencil holes, except for the extra holes out at the end of the panel. When you've finished painting, pull up the stencil: no need to wait.
If you want to extend the 3 point line or create solid lines, use the extra connecting stencils to paint between the dashes
Check out more basketball instructions
To Order By Phone Call Our Toll Free Number: 1-888-600-8545
For more information please contact us at firstname.lastname@example.org or 1-888-600-8545
Copyright 2013 basketball-court.com